I took off my intake manifold. I think i have the bolts and studs in the correct places but thing as not lining up and threading as well as I would hope. I am hoping someone can upload a photo of thier intake manifold that shows where each screw goes. I also attached the manual of the intake manifold if that helps.

 

Will take a couple of pics later today.

---AutoMerged DoublePost---

On my truck all the intake fasteners are studs,however the middle ones are longer due to the intake being thicker in that area-(1-8).

 

I figured it out by trial and error. Thier are six bolts, five short studs, and five long studs
The bolts go on: 9, 10, 11, 12, 14, and 16
the short studs go on: 15, 7, 6, 13, 8,
the long studs go on: 2, 3, 5, 1, 4
all studs/bolts except 9, 11, 13, 15 are loctight. thous 4 are done using thread sealer.