Fuel filter replace
#1
Fuel filter replace
Hey all I'm doing a few small things to my rig tomorrow morning and one of them is the fuel filter correct me If I'm wrong but I just need to loosin off the bleeder then the bigger black ring and remove old filter then put new one in, unscrew bleeder and crank engine till fuel comes out ?
Now the filter i got from napa has the black ring built into the filter, will this still work on my 6.5td s vin ?
Thanks in advanced !!
Now the filter i got from napa has the black ring built into the filter, will this still work on my 6.5td s vin ?
Thanks in advanced !!
#2
#4
#8
Thanks! I'll try to get up that way again to check it out. Wix makes a good filter, and any deal is a great deal.
---AutoMerged DoublePost---
When I'm changing the fuel filter, I unplug the OPS and use a jumper wire between the outer two terminals on the plug to run the lift pump. Its essentially the same process as using the ALDL connector and a battery, but this way puts both connections right near where I'm at. I think its easier, but to each their own.
---AutoMerged DoublePost---
When I'm changing the fuel filter, I unplug the OPS and use a jumper wire between the outer two terminals on the plug to run the lift pump. Its essentially the same process as using the ALDL connector and a battery, but this way puts both connections right near where I'm at. I think its easier, but to each their own.
Last edited by cviola2005; 03-21-2013 at 01:17 AM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post