It is located on the air box and there is no grounding wire from the relocation where or how is it grounded?

 

I have a grounding screw in my heat sink to the body this is a must otherwise PMD failure is just a matter of time

 

Can i run a ground wire from the heat sink to the frame because my pmd is mounted to plastic?

 

yep but you may need a new PMD

 

ok i will try grounding it and see thank you very much

 

So the truck is still stalling i went to the garage they think its the injection pump because when it stalls it is hard to start now he said tgere is an extended warrenty which there is because i called banks i cant find wat voids the warrenty do you know if anything i have listed would void the warrenty?

 

Not sure about the warranty but if it dies when warm and hard to start the easiest way to tell if it is the IP pour cool water on the pump next time a quart or so will be sufficent if it fire right back up it is the IP