Trouble starting after injector swap.
#1
#3
#5
1st make sure high pressure oil pump is full of oil, then crank engine over about a minute then check to make sure hpop is full of oil. Then crank for another minute. If high pressure oil pump stays full. After about 6 or 7 trys it should start. When I do it I all ways have the tank heater pluged in for a few hours.
Thread
Thread Starter
Forum
Replies
Last Post
GasItOut
12 Valve 2nd Gen Dodge Cummins 94-98
35
07-22-2015 01:11 PM
Blackdog15
12 Valve 2nd Gen Dodge Cummins 94-98
3
05-20-2015 10:49 PM