Can you smoke switch a 6.7???
Diesel Fan
Joined: Dec 2009
Posts: 33
Likes: 0
This smoke switch setup works!!! Just got done settin it up, rolled the coal at a set still and couldnt wait to roll down the road. I set my Edge Juice w/ Attitude on 6 (Hot Unlock), lugged it a gear, hit the pedal, and watched the smoke roll. I appreciate the thread guys. Keep the smoke, and the good times rollin!!!!
Diesel Enthusiast
Joined: Jun 2010
Posts: 176
Likes: 7
From: Bear Lake, Idaho
this might help out alittle more.
What you need:
-T-tap connectors
-16 gage wire
-100ohm 10 Watt resistor
-On/Off switch
-Shrink Wrap
**Tuner is needed to produce "thick" smoke**
Step 1:
Locate Map sensor.
Step 2: Tap into Pink(with yellow stripe) wire and solid Brown sire with T-tap connectors.
Step 3:
Tie 100ohm 10 Watt resistor into either wire (it doesn't matter what one)
Step 4:
Shrink Wrap around resistor.
Step 5:
Run wires into cab.
Step 6:
Locate where to mount switch.
Step 7:
Start truck and make sure she smokes before fully connecting switch. (if you have a boost gage it should read that you are at full boost once switch is flipped.)
Step 8:
Mount switch.
What you need:
-T-tap connectors
-16 gage wire
-100ohm 10 Watt resistor
-On/Off switch
-Shrink Wrap
**Tuner is needed to produce "thick" smoke**
Step 1:
Locate Map sensor.
Step 2: Tap into Pink(with yellow stripe) wire and solid Brown sire with T-tap connectors.
Step 3:
Tie 100ohm 10 Watt resistor into either wire (it doesn't matter what one)
Step 4:
Shrink Wrap around resistor.
Step 5:
Run wires into cab.
Step 6:
Locate where to mount switch.
Step 7:
Start truck and make sure she smokes before fully connecting switch. (if you have a boost gage it should read that you are at full boost once switch is flipped.)
Step 8:
Mount switch.
Diesel Bomber
Joined: Apr 2010
Posts: 1,363
Likes: 123
From: oklahoma
i wouldnt think it would be any more danger on what tuner your running just the better tuner your running prolly the more smoke your going to get i would say bully dog and smarty are a close race just preference is what i would think 
Diesel Enthusiast
Joined: Jun 2010
Posts: 176
Likes: 7
From: Bear Lake, Idaho
well it will work with stock exhaust, not sure how much smoke it would produce though, but what it would do is fill the dpf up, and then you would regen alot more trying to clean it out, thus ruining your fuel milage, trucks with stock emissions will still put out alot of smoke, but just alot more regens so it kills your fuel milage. But I doubt you would see but a little puff of smoke.
Diesel Bomber
Joined: Apr 2010
Posts: 1,363
Likes: 123
From: oklahoma
i would think it would work but like said in the other post you prolly wont get much more then a lil puff and lots of regen i let a buddy run my smarty for a day on his bone stock truck before i put the -me- on it and after we took it out the next day started getin codes for his emissions and it cracked his dpf 
but dodge replaced it no prob but i wouldnt do it to a stock one
but dodge replaced it no prob but i wouldnt do it to a stock one
