I have an 04 ford 6.0 I have removed the high pressure injector rail and it is fed from a braided line that one screws cinto the rail the other end 90s then goes into the block through the head can anyone tell me how to remove this line its all i have left before i can lift off the head and change my head gaskets

 

I believe 03/04 needed a special tool to get that line off if I'm not mistaken.

 

Where can I try to buy it I am stuck?

 

try e-bay

 

I used a wrench that came with a air die grinder it is the correct size and i didnt have to buy any special tool. I also used a socket to remove the injector wires from head.

 

Try these.

S3O31D20LHEAD.pdf

S3O31D19RHEAD.pdf

 

Awesome! I'm printing those out for the binder!

 

Im using a box end of a wrench that we cut out to fit over the pipe. got a good hold on it but its not breaking loose. It just seems like its bending the pipe down in the head or block. Any help???