i got a headgasket (came 2 in a pack) off a 05 that i had to swap the motor out of bc of scorched cylinder under warranty just wondering if the 05 MLS gasket will fit in place of the old style gasket in the 93 when the event of the blown headgasket occurs just wondering bc its got to hold better

 

With some small trimming yes.

Hold teh new up to the old

 

So this would be a good upgrade with some studs if u were planning on a set of twins on a first gen right?!

 

I seem to recall the MLS gaskets not holding up very well on the non-CR vehicles for whatever reason?

Or was that just the Cometic MLS gaskets?

 

Does anybody else know anything about this issue with the 3rd gen gaskets.

 

It was teh cosmetic MLS ones.

I want to say I've heard good things about running the CR MLS gasket on 12v's. I think you need to make a hole or something in it though.

 

using the old gasket as a stencil will eliminate the guessing; personall i have NO clue but my method of maddness would be to "stencil" the original trim it (or drill it) to be exactly like the OE

 

Yeah there is not much difference.