code after turbo instal
#1
code after turbo instal
So I installed my DPS compound setup on saturday. Since then I reloaded sw7 TNT on the smarty with the wastegate off. and ever since putting them on I've had this p243 code. Turbo solonoid short code. Not really understanding this since I turned the electronic gate off. Also, I've only got on it hard once but i'm only seein 30psi out of this thing. I went over all the clamps and boost tubes and their all tight. Any ideas?
---AutoMerged DoublePost---
Well I plugged the factory boost solonoid in and that took care of the code. Now its just why I'm low in boost? I went over all of the boots and clamps, and all tight
---AutoMerged DoublePost---
Well I plugged the factory boost solonoid in and that took care of the code. Now its just why I'm low in boost? I went over all of the boots and clamps, and all tight
Last edited by K80; 07-26-2011 at 06:30 AM. Reason: Automerged Doublepost
#3
Thread
Thread Starter
Forum
Replies
Last Post
avatardvr
Ford Powerstroke 03-07 6.0L
18
08-08-2019 12:38 AM