VP 44 tap probs
Thread Starter
|
Diesel Fan
Joined: Dec 2010
Posts: 66
Likes: 0
From: WV
injector pump?
I have also noticed the lift pump isnt kicking in when I bump the starter. I bumped the key on 3 times to see if it would give me any codes and it says NO BUS. Do you still think its the injector pump?
---AutoMerged DoublePost---
I ran the pump stand alone and the truck runs. Now I'm leaning toward the ECM or PCM? What do you think
---AutoMerged DoublePost---
You could pin out and verify the pump is getting required voltages, I've posted the connector pin out somewhere.
You could standalone the pump and see if the truck runs. Otherwise if no the vp has power the pump is done. Hate it for ya man.
Sent from my DROID BIONIC using Tapatalk
You could standalone the pump and see if the truck runs. Otherwise if no the vp has power the pump is done. Hate it for ya man.
Sent from my DROID BIONIC using Tapatalk
Last edited by jcrad; Feb 10, 2012 at 07:20 PM. Reason: Automerged Doublepost
Diesel Bombers Sponsor
Joined: Mar 2007
Posts: 3,791
Likes: 367
From: Blowing Rock,NC
Which code for no bus. Ecm would be the next inline for failure
I almost want to say that the pump may allow it run without communication in a standalone but don't hold me too it. Basically what im saying is while no communications could prevent it from running while hooked to the truck electronics but the standalone would still allow it to start. That's a pretty unlikely option but its something to keep in mind
Sent from my DROID BIONIC using Tapatalk
I almost want to say that the pump may allow it run without communication in a standalone but don't hold me too it. Basically what im saying is while no communications could prevent it from running while hooked to the truck electronics but the standalone would still allow it to start. That's a pretty unlikely option but its something to keep in mind
Sent from my DROID BIONIC using Tapatalk
Last edited by mysterync; Feb 10, 2012 at 07:35 PM.
Diesel Bomber
Joined: Jun 2007
Posts: 2,664
Likes: 153
From: Shingletown ca
I don't like the stealth plate as I had one and the thing broke and just caused issues solder it and shrink tube it you know it's connected
Thread
Thread Starter
Forum
Replies
Last Post
somarillw
24 Valve 2nd Gen Dodge Cummins 98.5-02
10
Dec 10, 2014 12:18 PM
