head gasket
#11
#12
ok thanks for clearing that up with me they tried to tell me that it was too much power for it and that it wouldnt hold but idk what they did with it. I had to go back and check what was wrong cause it had a fuel leak when i got it back and come to find out they didnt have the connector tubes popped down in there good and they try to tell me idk what im talkin about haha. But thanks again im goin to try the few heat cycles once i get another head gasket on it. Should they be like in the same day or maybe a few days apart when i retorque them or how should i do that?
#14
i actually didnt do the head studs the shop did it while they were doing the head gasket. But i know the order you are talkin about so whoever does my head gasket this time since i dont have the stuff here to do it. I will go back and retorque them or i will tell them to do it and watch and make sure its done right
#16
#18
#19
i got the studs in it. My special aint that laggy i mean it takes a min 2 spool but it really aint that bad. I have 2 quit blowin head gaskets b4 i do anything else
---AutoMerged DoublePost---
i have one more question when i retorque the studs after the heat cycles do i loosen them then torque them back down or just make sure that they are at 125 ft lbs??
---AutoMerged DoublePost---
i have one more question when i retorque the studs after the heat cycles do i loosen them then torque them back down or just make sure that they are at 125 ft lbs??
Last edited by moparfreak74; 03-29-2010 at 10:09 PM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post