Proper VP44 Pump Wire Tapping
#31
#32
I just hate purchasing from a non sponsor. No other sponsor will warrenty a tapped pump besides another 1600 dollar blue chip.
Does anyone know the truth about the computer sitting on top of these things? Blue Chip said other companies only replace them if they have to.
#33
Stealthplate is just, what it says, stealth... for warrantyreasons. It´s not the safest way connect the tap, but it´s better than the POS Scotchloks and similar. Best way to make the connection if you don´t have a very expensive crimpingtool is soldering... not very stealth, but makes for a good connection if done properly....
my 0.02$
my 0.02$
#34
Guys I ran into a little trouble need a little help.I got my plate yeasturday and started installing it I had trouble unscrewing those torx bolts and I actually stripped two of them but did got them out after forcing a torx 27 key in ,they were super thigt. So know I need to replace those two were can I get that type of bolt or can I replace them with diffrent bolt .
#37
#38
#39
The following users liked this post:
Fiveseven (01-16-2010)
#40
Ok so I finished installing my plastic cover on the vp44 that I got from Blue Chip and after I finished installing it when to turn it on and had the engine light on and I did the key thing to pull up the codes and I got this P0122 and P1693 and after that I turn the truck on and the light went out took it for a quick spin and it drove good as normal the light stayed off.Should I check something? By the way I did made sure the apps sensor was connected. Here are some pics .