I have a 98 12 valve and i want to take out the fule plate. What are the pros & cons?

 

pros: power, looking awesome, smoke, noise
cons: looking like a douche, smoke, noise, getting pulled over

 

pros:power, smoke.
cons: frying your clutch or tranny, unless your easy on it or have an aftermarket one

 

pros: closer to full rack travel, more fuel,
cons:egts more smoke..

i personally dont like it that well i did it in mine and i think im going to go back to a 0 plate.

 

i like mine the best with out fuel plate or afc.... thats tuning on demand
but lots of smoke and poor fuel milage, and no tranny

 

you get pulled over for smoke?

how would you look like a douche????

noise????? WTF

 

a o plate and no plate are the same.

pros: would be a big increase in power. i went from 150hp to 280 hp by changing from a stock plate in stock position to a 0 plate. no other pro realy imo

cons: excess smoke, high egts, easy to fry a stock clutch/torque converter, and decrease in fuel mileage, unless ya keep your foot out of it

 

Unless you have the means to push that much fuel, running plateless could potentially hurt you. Having a rack stop in the right place could be more beneficial then having full rack travel where you are basically overfueling and putting the fire out.

With a 0 plate slid a little forward from stock, I'm making 22 more hp than I was with out the plate.

 

i have run a 100plate ff and no plate and it seems the same on the butt dyno to me.

 

you aint guna notice a difference between 100 ff and no plate