Air Dog stops running?.goto 10micron?...
#11
#13
#14
I had a similar issue with my FASS. The engine brushes actually burnt up due to a bad ground.... It would be fine on moment, and then get interesting with fuel going up and down.
Got the pump engine replaced and ran a ground that can handle lightning. No problems thus far after a strong 20K....
Got the pump engine replaced and ran a ground that can handle lightning. No problems thus far after a strong 20K....
#15
I had a similar issue with my FASS. The engine brushes actually burnt up due to a bad ground.... It would be fine on moment, and then get interesting with fuel going up and down.
Got the pump engine replaced and ran a ground that can handle lightning. No problems thus far after a strong 20K....
Got the pump engine replaced and ran a ground that can handle lightning. No problems thus far after a strong 20K....
I have changed my filtre and put on a 10 micron. After about 2-3 hours of driving and things seemed fine, ...I was sitting with the truck idling and it dies again,...and the pump was not running after the engine quit while the key was still on. So the filter was not the problem what next?....
I put it in the shop to check the gear rotor on the back of the pump, though I'm think it is fine. I'll call Pure flow technologies again and see what else they say.
I'm wondering if the relay is getting weak?....
Any thoughts out there would be greatly appreciated....
Thread
Thread Starter
Forum
Replies
Last Post