Manual to Auto swap
#1
Manual to Auto swap
Hey guys, my knee has been acting up a lot lately and I've been toying with the idea of swapping my Nv5600 with triple disk clutch to a 48re setup. I kinda know the things that need to be swapped like the transfer cases and drive shafts and all that. I've done a lot of searching and can't find many people that's done this swap as most go from the auto to a manual. I was looking to get some advice from people that's done the swap or even just some input.
I'm trying to locate someone nearby with a ccsb truck like mine so that I won't have to buy any parts and just swap everything over, but would it be cheaper or easier to pickup a used trans and use a stand alone controller and floor mounted shifter? I can get a trans from a wrecked truck for about $1000. Any suggestions?
I'm trying to locate someone nearby with a ccsb truck like mine so that I won't have to buy any parts and just swap everything over, but would it be cheaper or easier to pickup a used trans and use a stand alone controller and floor mounted shifter? I can get a trans from a wrecked truck for about $1000. Any suggestions?
Thread
Thread Starter
Forum
Replies
Last Post
1ATony
1A Auto Parts
1
11-11-2015 10:03 AM