Needing a little help
#1
Needing a little help
So I just bought a 2006 5.9 cummins, I bought it knowing the turbo was bad and just replaced it. Now that I have it running its sounds like its missing. I did some feeling around on the fuel lines and I can feel pulsing in the number one injector line. Any ideas or help would be appreciated.
Thanks, Tanner
Thanks, Tanner
#5
Turbo
So I just bought a 2006 5.9 cummins, I bought it knowing the turbo was bad and just replaced it. Now that I have it running its sounds like its missing. I did some feeling around on the fuel lines and I can feel pulsing in the number one injector line. Any ideas or help would be appreciated.
Thanks, Tanner
Thanks, Tanner
Mine just went out.
#6
I would pull the valve cover off and check the connections on the injectors and make sure they are nice a tight if they seem good, take it off and then check the harness. It would be nice if you could get some one with an OBDII that can do a Injector Cut out test and check your injectors that way too. But do not run the truck very long because a bad injector can cause excessive heat in a cylinder and cause scoreing in the cylinder which will lead to loss of compression and will lead to a engine overhaul. If you are having hard start issues it may also be the cross over tube. I think my buddy ChaseW can vouche for that...
Thread
Thread Starter
Forum
Replies
Last Post
Oklahoma24v
24 Valve 2nd Gen Dodge Cummins 98.5-02
3
06-01-2015 07:24 PM
cooler364
12 Valve 2nd Gen Dodge Cummins 94-98
2
03-15-2015 04:13 PM
797Ram
Price Quote - Request A Price
0
03-09-2015 09:36 PM