Diesel Bombers

Diesel Bombers (https://www.dieselbombers.com/)
-   5.9 Liter CR Dodge Cummins 03-07 (https://www.dieselbombers.com/5-9-liter-cr-dodge-cummins-03-07/)
-   -   Needing a little help (https://www.dieselbombers.com/5-9-liter-cr-dodge-cummins-03-07/114234-needing-little-help.html)

DieselN00B 08-01-2013 10:28 PM

Needing a little help
 
So I just bought a 2006 5.9 cummins, I bought it knowing the turbo was bad and just replaced it. Now that I have it running its sounds like its missing. I did some feeling around on the fuel lines and I can feel pulsing in the number one injector line. Any ideas or help would be appreciated.

Thanks, Tanner

dangerous1965 08-02-2013 08:33 AM

Any smoke? Probably a bad injector.

DieselN00B 08-02-2013 12:58 PM

White smoke. I was also reading about bad injector wiring, is there some place I should check for that?

ChaseW 08-02-2013 10:39 PM

i was told the harness in the valve cover is bad about chaffin pull it off and clean it and ohm the wires my guess is injector tho to

dlbraly 08-19-2013 07:38 PM

Turbo
 

Originally Posted by DieselN00B (Post 1019578)
So I just bought a 2006 5.9 cummins, I bought it knowing the turbo was bad and just replaced it. Now that I have it running its sounds like its missing. I did some feeling around on the fuel lines and I can feel pulsing in the number one injector line. Any ideas or help would be appreciated.

Thanks, Tanner

Just curious what Turbo did you go with?
Mine just went out.

RanchhandTCR 08-19-2013 09:18 PM

I would pull the valve cover off and check the connections on the injectors and make sure they are nice a tight if they seem good, take it off and then check the harness. It would be nice if you could get some one with an OBDII that can do a Injector Cut out test and check your injectors that way too. But do not run the truck very long because a bad injector can cause excessive heat in a cylinder and cause scoreing in the cylinder which will lead to loss of compression and will lead to a engine overhaul. If you are having hard start issues it may also be the cross over tube. I think my buddy ChaseW can vouche for that... :c:


All times are GMT -5. The time now is 08:55 PM.


© 2024 MH Sub I, LLC dba Internet Brands