edge comp install
#1
#2
Aint no thing. I'm assuming you still have instructions. Its not a lot of wire to get at, meaning there is not much slack at all. I cut back the protective covering which makes it much easier to get at and see. And like it says the TOP INNER WIRE closest to the block. The tap-in connector is a pretty sweet design. You just need to go for it. I think I put the connector in place with needle nose pliers. I did not disconnect anything like it says may be done. My rig is an 02 but only difference should be where the MAP/Data link, it was near the frame rail. Try not to get the wrong wire I mean there is only two in that area but at least if you do snag the wrong one you will know when stuff does not work. I did mine about a month ago
The following users liked this post:
cumminscwby (11-29-2011)
#3
#7
#8
#10
Thread
Thread Starter
Forum
Replies
Last Post
Rusted Dragon
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
02-27-2015 09:46 PM