ball joint ?'s
#21
#23
I've replaced the bearing hubs 3 times on each sides of the truck and I just finished replacing all of the ball joints, tie rod ends and bushings. If you're gonna do any of this stuff, buy the right tools! The OTC hub puller is 70-100 bucks and will pull the hubs in about 30 seconds, no sweat. If you're going to do ball joints, get the big clamp press and the right adapters for your truck. If you have those tools, you can swap the ball joints out in 3-4 hours. When you do replace things, do yourself a favor and use Moog and Timken for the bearings if you need them.
#24
I used a puller for the hub and it pulled the hub apart. once I didnt that i brought it to someone cause I was tired of dealing with it...
---AutoMerged DoublePost---
anyone know where i can get steering knuckles for a d60 rather cheap?
---AutoMerged DoublePost---
anyone know where i can get steering knuckles for a d60 rather cheap?
Last edited by Jeff M; 03-11-2010 at 01:58 PM. Reason: Automerged Doublepost
#25
Thread
Thread Starter
Forum
Replies
Last Post
nickpro902
Diesel In Distress - Support Ticket
1
03-14-2015 08:46 PM