I need a fuel pressure guage...
#21
You will need a 0-60 psi guage for a 12V....as you should be seeing pressures over 30 psi.
Start a thread in this forum:
5.9L 12V Bombs (Aftermarket) - Diesel Bombers
Start a thread in this forum:
5.9L 12V Bombs (Aftermarket) - Diesel Bombers
#22
#25
You need a shutoff in case the gauge starts to leak in the cab - would be nice to be able to shut it off. You need a needle valve or pressure snubber to dampen the pulses from the VP-44 which protects your guage.
Yes, any pressure guage will work even though it doesnt say fuel pressure on it.
Yes, any pressure guage will work even though it doesnt say fuel pressure on it.
#27
#28
#29
hold on - be careful what your ordering hop sing that tapped banjo bolt thats shown above wont work on a 12V - its too small and you cant buy them either. You have to pull the stock banjo bolt that on the inlet of the P-7100 and tap it with a 1/8" npt tap.
Like I said start a thread in the 12V forums or do a search.. The info is there.
Like I said start a thread in the 12V forums or do a search.. The info is there.
Last edited by Dr. Evil; 03-02-2010 at 01:26 PM.
Thread
Thread Starter
Forum
Replies
Last Post