You will need a 0-60 psi guage for a 12V....as you should be seeing pressures over 30 psi.


Start a thread in this forum:

5.9L 12V Bombs (Aftermarket) - Diesel Bombers

 

thx too, Luke i looked at your store and i am going to order the isspro from u i wiil call u monday and order a pyro,boost,and fuel pressure ,keep my project money in the ohana! thx and mahalo Hop Sing

 

Glowshift is electric and these gauges are very nice if you are on a low buget set up

 

Why do you need a shut off on the mechanical gauge. Any old oil pressure gauge will work?

 

You need a shutoff in case the gauge starts to leak in the cab - would be nice to be able to shut it off. You need a needle valve or pressure snubber to dampen the pulses from the VP-44 which protects your guage.

Yes, any pressure guage will work even though it doesnt say fuel pressure on it.

 

hey Doc do u need a shut off if you have p7100 ? thx Hop

 

yes theres even more fuel pressure on a 12V

 

thx Doc!,do u know if diesel dawgs kit comes w/the setup in your install pics in the early post and thx again bro! this sight is a wealth of knowledge Aloha Hop Sing

 

hold on - be careful what your ordering hop sing that tapped banjo bolt thats shown above wont work on a 12V - its too small and you cant buy them either. You have to pull the stock banjo bolt that on the inlet of the P-7100 and tap it with a 1/8" npt tap.

Like I said start a thread in the 12V forums or do a search.. The info is there.