How to Instal 3200 rpm gov spring in VE pump?
#1
How to Instal 3200 rpm gov spring in VE pump?
I was wondering if anyone could give me instructions as to how to instal the gov spring in my rotary pump. i have already installed a denny t stage two fuel pin and now need to install my gov spring. pictures would be nice as well as to where its located, thanks
#2
Den - Dodge CTD 1st Gen - VE Governor Spring Install
My only suggestion is when you get to the part where you need to hook the spring to the shaft, push the shaft out of the pump top, hook the spring to it, then put the shaft back in the pump top. Doing it that way will save so much frustration and and will avoid the potential loss of the top hat and its spring.
My only suggestion is when you get to the part where you need to hook the spring to the shaft, push the shaft out of the pump top, hook the spring to it, then put the shaft back in the pump top. Doing it that way will save so much frustration and and will avoid the potential loss of the top hat and its spring.
#5
its under the AFC housing the big 4 bolt thing on the top of the pump
look here for how too's https://www.dieselbombers.com/1st-ge...en-sticky.html
and heres the spring
VE44 '366' spring installation - 1st gen - Dodge Ram, Ramcharger, Cummins, Jeep, Durango, Power Wagon, Trailduster, all Mopar Truck & SUV Owners.
look here for how too's https://www.dieselbombers.com/1st-ge...en-sticky.html
and heres the spring
VE44 '366' spring installation - 1st gen - Dodge Ram, Ramcharger, Cummins, Jeep, Durango, Power Wagon, Trailduster, all Mopar Truck & SUV Owners.
Last edited by big bad diesel 416; 01-02-2012 at 09:42 PM.
Thread
Thread Starter
Forum
Replies
Last Post
HardLuck
Diesel In Distress - Support Ticket
0
06-24-2015 08:04 AM
Gm3500
Chevy/GMC 6.2L and 6.5L
9
05-07-2015 11:01 AM