How to Instal 3200 rpm gov spring in VE pump?
 

I was wondering if anyone could give me instructions as to how to instal the gov spring in my rotary pump. i have already installed a denny t stage two fuel pin and now need to install my gov spring. pictures would be nice as well as to where its located, thanks

Den - Dodge CTD 1st Gen - VE Governor Spring Install

My only suggestion is when you get to the part where you need to hook the spring to the shaft, push the shaft out of the pump top, hook the spring to it, then put the shaft back in the pump top. Doing it that way will save so much frustration and and will avoid the potential loss of the top hat and its spring.

A flat head screw driver will wedge the hat in place also.

ok but where is the spring located lol

its under the AFC housing the big 4 bolt thing on the top of the pump

look here for how too's https://www.dieselbombers.com/1st-ge...en-sticky.html

and heres the spring
VE44 '366' spring installation - 1st gen - Dodge Ram, Ramcharger, Cummins, Jeep, Durango, Power Wagon, Trailduster, all Mopar Truck & SUV Owners.

Thanks for your help big bad! there was a ton of info on that page, i printed out a ton of info just on VE pumps, thanks!

your welcome bud!

You wouldnt happen to work at or own bigbaddiesel.com would you?