Killer dowel pin fix question
#1
Killer dowel pin fix question
While my 1st gen motor is still on the engine stand wanted to take a look at the pin, question is my gear housing has a step in it where the pin is and not flat like I see in most of pics. My motor is a 91. The kit I see comes with a flat oblong washer and wont work for me. Any suggestions???? Thanks...
#2
Just use a piece of stiff wire or just fab something else that will work. Read this.
https://www.dieselbombers.com/1st-ge...tml#post478933
https://www.dieselbombers.com/1st-ge...tml#post478933
#3
Thread
Thread Starter
Forum
Replies
Last Post