Wiring Harness For Motor HELP!!!!!!!
#1
#3
what part of it burnt up. and how did it get the whole thing. There are a couple companys on line search for (wiring harness repair). I have used one before on a burn vehicle they redid the whole harness and looked just like a factory job. Sorry I can't remember the company think it was wire gap. But I would try there if you have no luck in the junk yards.
The following users liked this post:
kieron_kohlmann (08-24-2011)
#4
I have found some at junkyard but their all the same age as the truck im workin on and my luck i could hook it up and it be fine one week and the next it might melt too but it was the alternator wires that melted everything in 3 big sections of the harness and i think i got it all repaired right idk ill see when i hook it back up it was 2 or 3 big blue wires that melted stuff and i think it's the ones related to the alternator i think not sure cuz from the right side of the motor there's 2 blue wires then they split into 3 and 2 go to the same place and 1 goes to a syloniod then the 2 that go to the same place go into 3 and 1 goes one way and the other 2 go the same way so it's kinda weird and i dont know awhole lot about this stuff but i think i got it figured out
#5
#7
Ok im not an electriction but the blue wires...... They keep melting..... Theres 2 of them.... Can i run 4 of them????? Would that keep it from melting? Less power through more wire??? Just an idea cuz i only like bout 30 mins of work on the harness so while i got it out i was gonna see if that would be a good idea
#8
sounds like a short somewhere. The blue wires control just about everything as I'm sure you have found out.
---AutoMerged DoublePost---
I have Mitchell/AllData, but i think the factory did a poor job of writing a manual for our specific trucks.
---AutoMerged DoublePost---
I have Mitchell/AllData, but i think the factory did a poor job of writing a manual for our specific trucks.
Last edited by kieron_kohlmann; 08-24-2011 at 12:28 AM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post
Mike H
12 Valve 2nd Gen Dodge Cummins 94-98
1
11-25-2014 03:13 PM
Powerplant95
Dodge Truck and Cummins Turbo Diesel Forum
1
10-16-2014 03:31 PM