fuel filter
#22
#25
#26
I just recently had the same problem with mine. You have to put that screw in part first. Take it off of the filter and screw it up in there, there should be a slot on it for a big flat head screwdriver. Or you could be like me and use a gasket scraper. Once you get it tight screw the filter on. Its a retarded setup but thats what the deal was with mine. You just have to get that screw on part tight before you put the filter on. I know that was a half a** explanation but you should get the idea.....
#28
This whole thread is jacked!
If your WIF sensor is leaking because of stripped threads, then I would do away with the WIF sensor, and use the filter suggested up there^^^^^ somewhere.
If your fuel heater(above your filter) is leaking, then I would try replacing the o-ring that goes between the heater and the head.
---AutoMerged DoublePost---
Yes, it will be too long.
If your WIF sensor is leaking because of stripped threads, then I would do away with the WIF sensor, and use the filter suggested up there^^^^^ somewhere.
If your fuel heater(above your filter) is leaking, then I would try replacing the o-ring that goes between the heater and the head.
---AutoMerged DoublePost---
Yes, it will be too long.
Last edited by slingshot; 04-17-2011 at 09:04 PM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post