Down pipe
#1
Down pipe
Looking to figure out a 4" downpipe on the cheap. Some one on here had shown how they made their own for cheap, just trying to figure out where to get the mandrel bends and the weld on v-band flange.
I have looked all over to try and find who it was that built their own and can't find any info on it. So I guess it's back to the research for now so I can figure out how to get this accomplished.
Any help is appreciated.
I have looked all over to try and find who it was that built their own and can't find any info on it. So I guess it's back to the research for now so I can figure out how to get this accomplished.
Any help is appreciated.
#2
Thread
Thread Starter
Forum
Replies
Last Post
ebg2g
5.9 Liter CR Dodge Cummins 03-07
1
03-29-2015 06:15 PM