My 1st mod
#1
My 1st mod
Today I got all the throttle out of my ve pump. Well all I could get easily. I backed the high idle screw out 8 turns witch put the linkage almost touching the fuel line. And I moved the throttle linkage to the inner hole. And I used a nut for a spacer to take up the slack in the cable. Got the idea from RSWORDS. Thanks man. I'm impressed. I still don't have gauges but didn't think this would hurt. It raised the rpm's quite a bit but not sure how much (no gauges). Does anybody think this will effect egt's? And is it possible to over rev the motor now? Also I was wandering what the differance is between this and the 366spring?
#2
There is a governor spring late regulates the rpm threw the pump via the governor spring. That what the 366 spring is, alows the motor to achieve higher rpm's by changing that spring. Only way the motor will go over that is if a runaway accures.
366 spring and a fuel pin are the best mods to start with and are fairly inexpensive.
About 120for a pin and 20 for a spring.
366 spring and a fuel pin are the best mods to start with and are fairly inexpensive.
About 120for a pin and 20 for a spring.
The following users liked this post:
martymc81 (03-28-2010)
#3
#4
Thread
Thread Starter
Forum
Replies
Last Post
tractorcrazy
Ford Truck and Powerstroke Turbo Diesel Forum
1
04-10-2015 04:27 PM