In need of a part!
#12
#18
#19
i'm sure a decent auto parts store could hook you up, if anything use a compression fitting, with a flared piece of tubing. i think the cooler lines realistically would be around 3/8 in... its usually the largest line auto parts stores stock. the threaded fitting might even screw into the cooler fitting, but it'll come pre-flared just gotta cut it to desired length, bend it and then use the compression fitting to tie it into the existing line. just use a bit of emery cloth or fine-ish grit sand paper to clean up the line and give it a nice clean surface for the ferrule to clamp around.
Thread
Thread Starter
Forum
Replies
Last Post
Jet A Fuel
Tech Article Submission
0
06-05-2015 03:28 PM
Diesel Bombers
General Diesel Related
0
03-04-2015 08:20 AM
jrsavoie
Chevy/GMC 6.2L and 6.5L
1
02-06-2015 09:44 PM
countryboy040993
12 Valve 2nd Gen Dodge Cummins 94-98
10
11-16-2014 08:21 PM