Valve Adjustment
#13
#14
#16
#18
its not a screw in tool it simply pushes in or out, has a little o ring on it that creates drag. big l is right though you have to be going very slow or the indent in the back of the cam gear in ingages will shear off the tit on the plunger and then your lost and you have a piece of extra plastic floating around in your front housing gear train...not good
#19
---AutoMerged DoublePost---
you dont screw anything.its just a push pin.Itll be hard to tell if your there.You have to push in while you rotate the crank.Not an easy task by yourself.Pull it out and stick your finger in there to see if your close.(be sure the engine cant start)
Last edited by stillcummin; 04-17-2010 at 08:32 AM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post
Bill in Ballard
Ford 83-94 6.9 and 7.3L General
3
03-13-2016 07:42 PM
Baradium
Ford 83-94 6.9 and 7.3L General
3
03-09-2015 07:15 PM
bonestock
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
02-01-2015 08:41 PM