driveshaft again
#1
driveshaft again
Well like an *** I thought that just cause my truck had a three joint shaft in it it needed a three joint shaft now I am in need of a 2 joint shaft for my truck got a three joint in good shape if anyone needs one. I don't know how or why but my truck had a shaft for a gas motor truck in it, much smaller in diameter and the u joints were way too small. Thanks Cassidy sorry for putting you out. So if anyone has a 2 joint shaft for a 93 Dodge CTD regular cab dually I will be glad to take it off your hands.
#2
#3
#4
#5
Crap man, I'm sorry about that.
So the shafts that I sent you have larger crosses on them than the crosses you had before? But the new shafts are the right length?
Because they sell adapter crosses, where one axis is bigger than the other one, so you can bolt a big u-joint to a little u-joint.
Like this.
http://broncograveyard.com/bronco/i-...er_u-joint.htm
So the shafts that I sent you have larger crosses on them than the crosses you had before? But the new shafts are the right length?
Because they sell adapter crosses, where one axis is bigger than the other one, so you can bolt a big u-joint to a little u-joint.
Like this.
http://broncograveyard.com/bronco/i-...er_u-joint.htm
Last edited by Begle1; 10-31-2008 at 11:05 AM.
#6
The shaft you sent is to long the ujoints are the right ones I was talking about the original shaft that was in the truck. The yokes and stuff out of the shaft will work if I have to go to a driveshaft shop. Mopar doesn't sell them anymore and if they did they are 400 and change for the front and 350 and change for the rear no joints or center bearing. Jim the owner of the local salvage yard knows me by name as do the rest and I am in the salvage yard every week no shafts there for me. So I am hoping someone on here has one or I will have to have one made.
Last edited by meclint692002; 10-31-2008 at 01:05 PM.
Thread
Thread Starter
Forum
Replies
Last Post
CumminsCoalRoller24/7
5.9 Liter CR Dodge Cummins 03-07
0
07-05-2015 06:30 PM