lookin to mod my 92 HELP!
#11
#12
---AutoMerged DoublePost---
I won't know how much of a difference though.
Last edited by bladeyamaha; 09-08-2012 at 01:43 AM. Reason: Automerged Doublepost
#13
---AutoMerged DoublePost---
not a super great upgrade its worth doing if you can get one for 300 or less
they will spool quicker (makes EGT's a little hotter) and flow just a little more air
but the spool is amazing over stock 1st gen especially if you have the 21cm
Last edited by big bad diesel 416; 09-08-2012 at 06:52 PM. Reason: Automerged Doublepost
The following users liked this post:
bladeyamaha (09-08-2012)
#14
yes it will you may have to knock the studs out or drill the manifold depending on setup they came with an HX35 and an HY35 if its the HY dont bother the HX is a nice little upgrade if its a late model HX you will need a adapter for the HP oil inlet line and find a 90* adapter to come off the turbo to fit the IC pipe or to the crossover tube silicone hose adapter will work too the stock 90* off a 1st gen turbo bolts right up make sure you replace the gasket stock 1st gen down pipe bolts right up
---AutoMerged DoublePost---
not a super great upgrade its worth doing if you can get one for 300 or less
they will spool quicker (makes EGT's a little hotter) and flow just a little more air
but the spool is amazing over stock 1st gen especially if you have the 21cm
---AutoMerged DoublePost---
not a super great upgrade its worth doing if you can get one for 300 or less
they will spool quicker (makes EGT's a little hotter) and flow just a little more air
but the spool is amazing over stock 1st gen especially if you have the 21cm
#16
you can run 40hp, 90hp, 140hp, and 200hp on stock pump
the 140's i sell the most great street and strip injector
Thread
Thread Starter
Forum
Replies
Last Post