pulled head any thoughts on rebuild or not?
#1
pulled head any thoughts on rebuild or not?
Well i pulled the head off the engine today and am a little worried about if i should run it or not with out a rebuild. all the cylinders look pretty good except for number 3. there's some obvious signs of wear in it. there's a few wear marks on the cylinder wall but i can barley catch only 2 of them with my finger nail. and i can barley catch any of a lip at the top of the cylinder telling me there probably wasn't to much more then 100-120 thousand miles on this engine and it rotates freely no binding or play. not sure if i should have it rebuilt or if it would be fine to keep running for a long time. the blow by tube isn't all gummed up from oil it looks pretty clean.
I don't have a lot of money to do this swap right now so that's why i'm contemplating on if i need to have it rebuilt or not. any thoughts on if its okay or a ticking time bomb ready to go off right after the install
I don't have a lot of money to do this swap right now so that's why i'm contemplating on if i need to have it rebuilt or not. any thoughts on if its okay or a ticking time bomb ready to go off right after the install
#2
#4
#6
Thread
Thread Starter
Forum
Replies
Last Post
TheMacster
5.9L 24V Performance
2
04-14-2015 07:01 PM
klein444
6.2L & 6.5L Performance
7
04-14-2015 09:04 AM
Diesel Bombers
General Diesel Related
0
10-31-2014 08:10 AM