93 rearend in my 98
#1
93 rearend in my 98
Will a 93 auto rearend with 3:55s go in my 98 5spd that has 4:10s.I like the power of the 4:10s but id rather get better mileage and not be at 2500 rpm goin
70.both are 2wd.
---AutoMerged DoublePost---
ANYBODY!!!!!!!!!!!!!
70.both are 2wd.
---AutoMerged DoublePost---
ANYBODY!!!!!!!!!!!!!
Last edited by smokedout; 02-01-2012 at 02:38 PM. Reason: Automerged Doublepost
#2
#3
#4
i'm not sure how much narrower they are but the 2nd gen trucks are wider & i run 10x16s on both my 01&89 the 89 tires are under the fenders,the 01 they stick out 2in's.plus i don't know if the spring perches would work without cutting them off and relocating them.the angle may be diff too.it would be easier to have an axle shop change gear sets & if you can swing it have them tighten up your posi unit so your not doing one wheel peel burn outs.
#5
#7
93gears
after rethinking this no i don't believe the 3.07's will work in the newer axle.in order to use 3.07's in my 89 i had to change the housing.the pinon is in a diff. location.if it were a 3.55or 3.73 it would work.i had my buddy put the 3.55's from my 89 in my 01 axle when i blew the gear set in it.i can check with my friend if you'ed like but i do believe the make like a 3.12 set that will fit in your 98.
Thread
Thread Starter
Forum
Replies
Last Post