Starting
Truck starts but almost have to run it like a old carbureted gasser, have to hold 1/4 throttle and fires right up and then idles fine. Just wondering if this could be as simple as adjusting the fuel shut off solenoid rod? Didn't want to go tearing into anything until I got some input.
Yea just until it fires, then it idles on its own fine, stock injectors but fuel plate is custom ground.
A lot of guys run a choke cable or some kind of cable from throttle linkage to the inside the truck so you can warm it up a little better. I had the same problem but i looked into it and found i had a wire loose on my fuel heater. I hooked that back up and it took care of the problem.
Thread
Thread Starter
Forum
Replies
Last Post
GasItOut
12 Valve 2nd Gen Dodge Cummins 94-98
35
Jul 22, 2015 01:11 PM
gunman41mag
The Sportsmen's Lounge
0
Jul 1, 2015 10:21 AM
hurriedcoyte
Diesel In Distress - Support Ticket
3
Jun 19, 2015 06:26 AM



