nv4500 Swap Safety Neutral Switch
#1
nv4500 Swap Safety Neutral Switch
I have completed everything on an auto to manual swap. I know there are several posts about this issue but im having just a lil bit of a problem understanding them. The only thing i need help with is exactly what two wires to cut for the safety neutral switch and where to splice them in to. Some post i have read say to ground one wire out, and another said to run a certain wire from the existing auto harness to one of the wires on the switch and to ground out the other wire on the switch. im confused. i know this is a very simple procedure but i just want to make sure what im doing before i start cutting wires. Can anyone please help? Any input would be greatly appreciated.
#2
#3
Hey thanks for taking the time to reply back.Sorry i didnt word that right. What i was trying to figure out was how to take the existing wires to the auto safety switch and tie them in to the clutch switch. I have thought of just bypassing the switch but with kids around i would rather be on the safe side. I have seen on other threads kinda what wires they are talking about running to the clutch switch but it doesent pin point exactly what wire to tie into the switch and which one to ground. kinda lost. I think i know which ones but would rather make sure before i cut wires. Any ideas out there on exactly what wires are involved or to any links to any other threads that may help me out? Thanks to everyone.
#4
Thread
Thread Starter
Forum
Replies
Last Post
Jonrarick
12 Valve 2nd Gen Dodge Cummins 94-98
3
10-25-2016 01:32 PM
IslanderXJ
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
12-17-2014 04:14 PM
CumminsMan2.0
24 Valve 2nd Gen Dodge Cummins 98.5-02
1
12-11-2014 04:57 AM