hey i got my afc off and took it apart to make some changes, i took the adapter fitting for turbo boost to put shop air to it? i noticed that the adapter fitting had a snubber in it, or a very small hole in it, does any one know if drilling the hole out would allow it to see boost faster? would it help?

 

no.. the smaller hole the more boost. some people plug the line off.

 

why is it then when you buy a fuel plate the boost elbow they send you has such a big opening?

 

im talking about the brass fitting that goes into the afc housing for the diaphram.

---AutoMerged DoublePost---

any way i drilled it out and i noticed a little bit of a diff in throttle response

 

thought you were talking about the elbow on the turbo.

 

no the one going into the afc had very small hole in it mabey 1/32, so i drilled it out to 1/8

 

did you notice much of a change at all?

 

it seemed like the afc fueled up little quicker when i stomp on it from a dead stop.