Trans Temp Gauge Help
#12
Looks like this:
DieselManor - Dodge Generation 3 Cooler Line
Your 97 may or may not have it because for some stupid reason they quit putting this line in - I thought in model year 1996.
No worries though, if you dont have that line from the factory, you can still put it in with this:
Cooler Line Manifolds at DieselManor
And if hat doesnt tickle your fancy, you can use this in the pan - you install this in the side of the pan and screw your temp sender right into it:
http://www.genosgarage.com/prodinfo.asp?number=BM-80250
DieselManor - Dodge Generation 3 Cooler Line
Your 97 may or may not have it because for some stupid reason they quit putting this line in - I thought in model year 1996.
No worries though, if you dont have that line from the factory, you can still put it in with this:
Cooler Line Manifolds at DieselManor
And if hat doesnt tickle your fancy, you can use this in the pan - you install this in the side of the pan and screw your temp sender right into it:
http://www.genosgarage.com/prodinfo.asp?number=BM-80250
The following 2 users liked this post by Dr. Evil:
rkadcock (10-22-2009),
turbo20psi (10-23-2009)
#14
Looks like this:
DieselManor - Dodge Generation 3 Cooler Line
Your 97 may or may not have it because for some stupid reason they quit putting this line in - I thought in model year 1996.
No worries though, if you dont have that line from the factory, you can still put it in with this:
Cooler Line Manifolds at DieselManor
And if hat doesnt tickle your fancy, you can use this in the pan - you install this in the side of the pan and screw your temp sender right into it:
http://www.genosgarage.com/prodinfo.asp?number=BM-80250
DieselManor - Dodge Generation 3 Cooler Line
Your 97 may or may not have it because for some stupid reason they quit putting this line in - I thought in model year 1996.
No worries though, if you dont have that line from the factory, you can still put it in with this:
Cooler Line Manifolds at DieselManor
And if hat doesnt tickle your fancy, you can use this in the pan - you install this in the side of the pan and screw your temp sender right into it:
http://www.genosgarage.com/prodinfo.asp?number=BM-80250
#15
i did think of that as we just got done replacing the lines on our 98. the ones listed for the 98 were wrong; the ones for the 97 had the port you guys are talking about on the scematic; but not on the physical line itself. so 96 is probably the safer bet that they stopped using this design
#16
Thread
Thread Starter
Forum
Replies
Last Post
JDurks2
24 Valve 2nd Gen Dodge Cummins 98.5-02
16
06-07-2015 08:57 PM