some help.
make sure you be careful not to break your crank postion sensor, its 125 bucks for a new one and wont run right without it, make your own tab its easy and cheap, i have pictures of mine in my profile if you want to take a peak.
Diesel Bomber
Joined: Mar 2007
Posts: 8,658
Likes: 504
From: Wisconsin
FormerVendor
Joined: Jun 2007
Posts: 3,196
Likes: 136
From: Fayetteville AR
Thread Starter
|
Diesel Enthusiast
Joined: May 2008
Posts: 200
Likes: 3
From: san diego california
how much time am i looking at here to do this thing?
---AutoMerged DoublePost---
i looked here and it said theres more than one? is this true or did i miss understand?
---AutoMerged DoublePost---
Last edited by navalseabee; Mar 12, 2009 at 10:49 PM. Reason: Automerged Doublepost
Diesel Bomber
Joined: Jan 2008
Posts: 4,525
Likes: 103
From: Havre mt
one killer dowel pin, two dowl pins total but you dont have to worry about the bottom one it isnt in the gear case, it did mine whil ei was overhauling my engine but it shouldnt take more than 3 hours, i help on one of my budies 98 12 last month he did the work i did the directing
I did mine without even tackin the fan shroud off., just pull the fan off, and you can get to everything, i would also recomend takein the upper radiator house off, it onley took me 2 hours to do, would of been quicker if i didn't break my cps and i also made my own tab! Just take your time and watch what your doing.
Super Moderator
Joined: Jun 2008
Posts: 5,812
Likes: 333
From: puyallup,washington
I didn't have to remove the bumper when i had mine done.And if you take out your radiator and intercooler while doing the job,blow out both of them to.That'l help the engine run a little cooler.
