4x4 Broke
The following users liked this post:
LOGANSTANFORTH (03-27-2008)
#12
The following users liked this post:
LOGANSTANFORTH (03-28-2008)
#13
#14
I can't recall ever seeing stripped splines on a D60 shaft, usually when they break they break at the shaft. Are you sure your spider gears aren't broken? Anything is possible, I would just be really shocked if you some how stripped the splines on that shaft. One sure way to find out is to pull it!
Chris
Chris
The following users liked this post:
LOGANSTANFORTH (03-28-2008)
#15
I think I figured out your broken english.
do you mean that when the truck is on the ground the ring and pinion will spin if turning the drive shaft? If so I'm not sure if that is an acurate test unless you have a LSD in the front instead of an open diff. Because without the CAD engaged the diff will spin.
I seriously doubt you broke the shaft (anything is possible but not likely).
How did you check your CAD. vacuum leaks can cause the fork not to move or be able to push the sleeve over
do you mean that when the truck is on the ground the ring and pinion will spin if turning the drive shaft? If so I'm not sure if that is an acurate test unless you have a LSD in the front instead of an open diff. Because without the CAD engaged the diff will spin.
I seriously doubt you broke the shaft (anything is possible but not likely).
How did you check your CAD. vacuum leaks can cause the fork not to move or be able to push the sleeve over
The following users liked this post:
LOGANSTANFORTH (03-28-2008)
#16
Thread
Thread Starter
Forum
Replies
Last Post
Diesel Bombers
Latest Automotive Industry News
0
01-20-2015 03:01 AM
Diesel Bombers
Latest Automotive Industry News
0
12-07-2014 11:20 AM
Sculpturesylvan
General Diesel Related
0
10-18-2014 10:19 PM