Are you guys doing any conversion Injectors for P-Pumped 24 valves?

 

i think to get your injectors to work with a p pump is lower the pop pressure a little. IIRC...

 

could a get some prices? set for a 12v. 100 or 150 horse... thanks

 

To properly convert a 24v injector you need to replace the compression spring, I have a set in CA that are being tested for spring rate. I plan on having springs produced that are the physical dimension of a 24v spring but have the rate of a 12v spring. The only other option is to sleeve the body and use a 12v spring, and this is neither cheap or easy.

 

dont some guys run a 24 valve injector still though?? Im just asking not saying

how long til you get the results back and start making the p-pumped 24 v injectors

 

alot of guys are still running there stock 24v injectors.

 

You can use a standard 24v injector, but it is far from ideal.

 

Weston, Who has done any real dyno testing with some of your sticks so far? I know Andy did a back to back, hear alot of people seem to like them but havent seen anybody talk about any personal numbers made with them.

Brett

 

Many have been dynoed, just a lack of back to back testng. I will send a few sets out to compared later this year, I'm busy trying to catch up as of now.

 

I have a used a lot of Weston's injectors and his always perform better than the previous we had in them. We haven't dyno'd back to back but have pulled and swapped and re-pulled. I definitely like his the best and he has the best knowledge out there and is not a BSer.