How do they compare to the DDP 95's 8 hole flowing 39 lpm?
Thanks!

 

You have a PM Mike

 

So what lpm are the 5x14 injectors. Also what do you do to the injector. Is it only pushing the holes out bigger or do you do internal mods??

 

Beave, you know DDP is the best, what info are you looking for here?

 

Beave you have a pm.

 

Well I know that the DDP injectors that are in my truck work well in my set up. as for what info I am looking for, I have already got an answer.

 

Could use some CR injectors maybe smokem needs a test truck in IOWA

 

 

If that's the case I'll take my truck done there and he can have it till it's done

 

Chris and Jamie will most likely handle all CR nozzles, Extrude Hone is used for these applications. As far as the 12v and 24v injectors are concerned, I am finishing up making a few alterations to the nozzle type and pintle design so that manufacturing can proceed. I would like to add a secondary needle guide to the older mechanical style nozzles such as the CR uses. This would prevent uneven seating area wear and low lift needle deviation.