[QUOTE=Whitmore;25706]cool man..now get you a chunk of 3/8" pipe insulation the foam stuff and run it down the stick to the rubber boot



I got a better Idea!

This is a proto-type, the second verson will have flushed set screws for the ****!

Thanks for the insperation Whitmore!

 

so how much, i see the start of a basement enterprise here, care to make any for the old 5spd guys with the bent shifter, that looks absolutely awsome

 

I'm not sure how one would look bent, I suppose I could try? Here is the problem with the basment enterprise, I've got $60 bucks and 2 1/2 hours labor into the shaft and ****. USPS.com says shipping would cost $5 to $10 flat rate. I'd have to get at least $100 bucks to make it worth it to me to mass produce. Send me a pic of your bent shifter, I've never seen one.

 

this aint my truck, i dont have an interior pic of it but heres what one looks like, im not sure if it woudl look good or not, i wonder if you can use the straight shifter on the older trucks

 

I haven't really built anything to special for my truck.
My trailer didn't have a loading ramp when I bought it so I built one; here is the ramp I finished a few weeks ago.
I used 1x1 square tubing to support the plywood with 1x2 side rails. I made the hinge out of 2X2 angle and 1/4 x 3" flat stock. It folds up flush inside the back door and I built a locking latch to hold it in place.

 

Have been playing around with where to mount 3 gages, have a Sony radio with CD/cdrw player extra i bought some month ago, found this under dash radio bracket, bought pigtails from factory radio, is a premium unit with CD player, to Sony unit
Waiting on 2 more gages i ordered from VULCAN, is going to install and connect a 3 along with low pressure light, have one light in one to go.
Took light from pocket, placed it above radio, so it is easier to change Cd's at night.
Have a pump relocating kit there need to be installed too, will do that when i adjust valves and have my injector pump friend to check/ rebuild/ replace tips as needed. Do rebuild injectors ( Lucas and repair cav pumps ), just don't have the setup for Bosch.

 

Side pic from right door, remote for radio/cd is behind cup.

 

thats looks nice.......you should market them

 

Thanks, that what i told Eric at Vulcan he should do, is getting the rest of gages from Vulcan this week.
Bought a edge comp, think i will mount it on the radio.

 

where did you get that radio mount...i need one also since that cubby hole is useless to me