Edge Comp Drag Version

Thread Tools
 
Search this Thread
 
  #1  
Old 06-04-2010, 02:07 AM
Uncle Bubba's Avatar
BOMBARDIER
Thread Starter
Join Date: Mar 2007
Location: Illinois?
Posts: 12,854
Received 1,112 Likes on 700 Posts
Default Edge Comp Drag Version

I am selling my Edge Comp Hot Unlock Drag Version for 1998.5-2000 along with a Blue Chip Stealth Injector Pump Cover for easy tapping of the pump wire and a dash mount for the box. I just received this box and wiring harness back from Edge today and had the the whole thing checked out and updated so it has the very latest upgrades available. Version 12.8HOT. So no worries about anything being bad with this box, it's good as new. This Box alone sells for over $750 from Edge, I'm askin $550 for the whole package.


The following is the manufacturer description for the straight Comp Box. I can't find anything on the Hot Box in particular but it would be the same as listed below with the exception of level 5:

Level 0: Stock
Level 1: 40 Horsepower - 150 Foot Pounds of Torque
Level 2: 60 Horsepower - 200 Foot Pounds of Torque
Level 3: 80 Horsepower - 250 Foot Pounds of Torque
Level 4: 100 Horsepower - 300 Foot Pounds of Torque
Level 5: 120 Horsepower - 350 Foot Pounds of Torque

The Edge Comp module maximizes engine efficiency by monitoring the RPM, timing, turbo boost pressure and fueling parameters. The module uses this information to determine and control both fueling and timing enhancements for the Bosch fuel injection pump. Timing and fueling enhancements are controlled via CAN-BUS through the Data Link and by connecting directly into the Bosch fuel injection pump.

The Edge Comp features five power levels with power gains from 40-120 horsepower. Each of the five power levels has an independent five-level adjustable responsiveness setting, providing for a total of 25 levels of adjustability! The responsiveness settings enable you to dial-in the optimum balance between responsiveness and low boost smoke control, no matter what additional power modifications have been made to the engine. The Comp module is fully adjustable on the fly and mounts inside the cab.

Sub-levels 1-3 on the Comp will provide de-fueling below stock. The de-fueling mode is entered only when rpm and boost are below a set value and stock fueling is being increased beyond a set rate. These conditions are different for each sub-level 1-3. During operation, when the de-fueling mode is entered, the rate of fueling increase is limited, which reduces smoke. De-fuel mode is exited once stock fueling equals the fueling controlled by the Comp. This way the transition is smooth and cannot be felt while driving. De-fuel mode is entered the easiest in sub-level 1 and has the smallest allowable fuel increase, while sub-level 3 de-fuel mode is not entered as easily and has a larger allowable fuel increase.

Sub-levels 4 and 5 allow adjustment of the additional fueling above stock based on boost level. Sub-level 5 adds the most fuel at low boost; Sub-level 4, which adds less fuel than Sub-level 5, corresponds to jumper setting 2 on the EZ.

The amount of additional fuel added is calculated, the amount actually added after being compared to boost from the total is as shown below:

Sub level 1: 33% is added at 0 psi boost
100% is added at 20 psi boost

Sub level 2: 50% is added at 0 psi boost
100% is added at 15 psi boost

Sub level 3: 67% is added at 0 psi boost
100% is added at 10 psi boost

Fuel may be added at 0 psi boost on all Sub Levels and EZ Jumper settings unless the de-fuel mode is entered as described above.

Power Level 1 on the Comp is the same as the EZ; on Power Levels 2-5 additional power is added via the wire tap onto the injection pump. If the pump wire is not attached with a Comp, Levels 2-5 are still operational, but the power gain is not any higher than Level 1. Under this scenario, however, power will come on much earlier in the throttle.
 
  #2  
Old 06-08-2010, 10:58 AM
Uncle Bubba's Avatar
BOMBARDIER
Thread Starter
Join Date: Mar 2007
Location: Illinois?
Posts: 12,854
Received 1,112 Likes on 700 Posts
Default

If nobodies here's interested I'm gonna list this on Ebay here in the next few days, so speak now or forever hold yer peace. I need this thing gone before I decide to put it back on my truck.
 
  #3  
Old 06-08-2010, 11:06 AM
Dr. Evil's Avatar
BOMBARDIER
Join Date: Mar 2007
Location: North of You
Posts: 23,293
Received 1,322 Likes on 1,071 Posts
Default

P-Pump?
 
  #4  
Old 06-08-2010, 11:57 AM
01quadcab's Avatar
Diesel Bomber
Join Date: Jun 2007
Location: Shingletown ca
Posts: 2,664
Received 153 Likes on 136 Posts
Default

no I think he is not going to use a box and just add injectors he can't keep vp's in his truck for too long if I remember the thread a while back
 
  #5  
Old 06-08-2010, 09:47 PM
Uncle Bubba's Avatar
BOMBARDIER
Thread Starter
Join Date: Mar 2007
Location: Illinois?
Posts: 12,854
Received 1,112 Likes on 700 Posts
Default

Yep, hopin to sell this and use the money for the new injectors and then someplace down the road pick up a SMARTY. I have no need for speed, this thing was always just a play toy to have fun with. In the real world I need the low end grunt for haulin the heavy trailers.

Edge did replace the wiring harness on it because they found a problem with it and it was out of date on the program version so they fixed that up to. I've said it before and I'll say it again they have the best customer service of any company I have ever dealt with. This box is 10 years old and they still fix anything that goes wrong for free.
 
  #6  
Old 06-14-2010, 02:52 PM
chpmnsws6's Avatar
BOMBARDIER
Join Date: Feb 2008
Posts: 207
Likes: 0
Received 9 Likes on 8 Posts
Default

 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
RexShoppe
Price Quote - Request A Price
1
11-23-2015 02:38 PM
Rusted Dragon
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
02-27-2015 09:46 PM
scottxmorris
24 Valve 2nd Gen Dodge Cummins 98.5-02
6
02-06-2015 05:33 AM
FF131
24 Valve 2nd Gen Dodge Cummins 98.5-02
3
01-21-2015 11:37 AM
scottxmorris
24 Valve 2nd Gen Dodge Cummins 98.5-02
1
12-31-2014 03:20 PM



Quick Reply: Edge Comp Drag Version



All times are GMT -5. The time now is 12:38 AM.