1 or 2 piece driveshaft
#1
1 or 2 piece driveshaft
Posting in here to get input from all brand camps. My driveline flew apart while I was driving down the road and I need a new one. My best guess is the carrier bearing somehow failed and caused the whole thing to just start whipping around.
I can get another 2 piece from the junkyard from around $100-150 just like the one I had
or
I can get a Tom Woods 1 piece made for $350. Keep in mind I don't really have the money for this option and I'd have to come up with it, but I'm wondering if anyone has experience with going from 2 to one piece or an opinion on the matter. My angle is pretty harsh which is why I haven't gone to a 1 piece yet, and I'm not sure if I'm better off staying with a 2 piece or going to a one piece with harsher angles.
If I get the one piece I'm going to tilt the motor/trans back a bit and probably shackle flip the rear to help out a bit, but in the end its still a pretty good angle.
I can get another 2 piece from the junkyard from around $100-150 just like the one I had
or
I can get a Tom Woods 1 piece made for $350. Keep in mind I don't really have the money for this option and I'd have to come up with it, but I'm wondering if anyone has experience with going from 2 to one piece or an opinion on the matter. My angle is pretty harsh which is why I haven't gone to a 1 piece yet, and I'm not sure if I'm better off staying with a 2 piece or going to a one piece with harsher angles.
If I get the one piece I'm going to tilt the motor/trans back a bit and probably shackle flip the rear to help out a bit, but in the end its still a pretty good angle.
#2
#4
#5
#6
Thread
Thread Starter
Forum
Replies
Last Post
CumminsCoalRoller24/7
5.9 Liter CR Dodge Cummins 03-07
0
07-05-2015 06:30 PM
5.9sledhead
Price Quote - Request A Price
0
01-26-2015 03:19 PM