hey yall. well i took my stacks off they were 5in turn outs. i installed my 5 in dual exhaust and i gotta say i miss the sound of the stacks. my duals sound good but....anyway i want something different. now i know it has been done because i have seen it its just not done alot. i want 2 - 5in miter cut stacks side by side on the right side of the bed.and when i say side by side i mean about 1/2 inch apart just enuff to clean between em...does anyone know of a place where i can get a adapter to do this? or if you have the same setup how did you do it???

 

ya.............just the regular "Y" pip will work just fine...............I think you will end up with a few maybe 4" tween them though...................unless you could find a couple of 4 to5 reducers that are essentric (offset)

 

 

I can build you a couple 4x5 essentrics