stack install
#1
#2
Get a 90* pipe and attached that to some flex pipe, which attached to the exhaust under the bab.
Next you need to figure out where to put the hole in the bed. Make sure you measure two three times so you only cut once.
Once you have the hole the bed, rund the pipe up into the bed and throw on your stack. Make sure you bolt down the stack on the up pipe.
Next you need to figure out where to put the hole in the bed. Make sure you measure two three times so you only cut once.
Once you have the hole the bed, rund the pipe up into the bed and throw on your stack. Make sure you bolt down the stack on the up pipe.
Thread
Thread Starter
Forum
Replies
Last Post
Diesel Bombers
General Diesel Related
0
04-29-2015 08:20 AM
ramrunner01
24 Valve 2nd Gen Dodge Cummins 98.5-02
3
01-19-2015 05:01 PM
Gman30
5.9 Liter CR Dodge Cummins 03-07
2
12-27-2014 12:46 PM
Cody Cain
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
12-22-2014 01:27 PM
Cody Cain
Diesel In Distress - Support Ticket
0
12-21-2014 06:50 PM