THE 'HOW TO POLISH ALUMINUM' TUTORIAL
#31
After reading this thread and I have taken out the intake to clean it, the bug bite me.
I would love to polish the intake, the water return bridge and the valve cover.
My question is: would you remove the "support braces" at the intake? It would me much easier to trim them off.
But I don't know if this could effect the strength of the intake?
I'm also going to polish the inside of the intake to a mirror like finish. No more casting flash or leftover metal inside. I would like to provide a smooth surface for intake air.
Not sure if it will bring any benefits, beside from making more difficult for soot and oil to stick on it.
I would love to polish the intake, the water return bridge and the valve cover.
My question is: would you remove the "support braces" at the intake? It would me much easier to trim them off.
But I don't know if this could effect the strength of the intake?
I'm also going to polish the inside of the intake to a mirror like finish. No more casting flash or leftover metal inside. I would like to provide a smooth surface for intake air.
Not sure if it will bring any benefits, beside from making more difficult for soot and oil to stick on it.
Thread
Thread Starter
Forum
Replies
Last Post
Diesel Bombers
Latest Automotive Industry News
0
08-05-2015 03:40 PM
Diesel Bombers
Latest Automotive Industry News
0
04-16-2015 10:10 AM
Diesel Bombers
Latest Automotive Industry News
0
04-11-2015 04:01 AM
Diesel Bombers
Latest Automotive Industry News
0
03-13-2015 03:40 PM
Diesel Bombers
Latest Automotive Industry News
0
03-12-2015 03:50 PM