with that modified pod, where you have the 2 lower gauges. how far off the factory dash piece does that sit?

 

nice work, i think i like it better than the a piller. how is it installed, and where did you get it?

 

Riffraff Diesel Performance Parts | Ford 7.3 diesel | 7.3 powerstroke | Ford Powerstroke | 7.3L Powerstroke Parts

they have them.

 

It sits flush minus the thickness of the overlay...

Riff Raff has it, as well as several other vendors. The bottom drivers side is a bit of a bitch, be prepared to "modify" the factory gauge bezel... Dont go any higher then I did...

 

im not impressed by my Autometer Cobalt series C2 gauges. I am half tempted to rip them out and do old school autometer mechanical gauges.

 

Did you get them put in?

Sent from my DROID BIONIC using Tapatalk

 

Hope to make time next week.

Luke

 

Joe- so you need to cut into the factory bezel?

 

Not to just install the two gauges... To install the bottom two, yes.

 

that's what i was asking. i think i might change to that. pod.