Upper Console Message Center
#1
Upper Console Message Center
Tryin to figure out why my upper console message center would have quit working. Owners manual does not have a specific fuse location for this feature. F-250 2002 7.3. Quirky little problem but I try to eliminate items on laundry list whenever I get bored! It's nice to know which direction I am going, ya know! Thanks for any suggestions!
#3
Here is what i used to fix mine tried to seach for it on this site no luck
Ford Powerstroke Diesel Forum
Ford Powerstroke Diesel Forum
#4
Thanks. I checked the 19th hole and it looks fine, also says in the book that fuse is for "Body Security Module/4x4 module". Not sure that this the same fuse you had mentioned above. Screens are definitely OUT!
#5
Powerstrokin02 check that post, those overhead computers have a problem with the resistors after awhile will come lose and to fix them all u will have to do is resolder them back in to place and wham bam thank you mama it works again but if there is a different problem search on ebay for ford overhead computer there is a company that will fix for around 30 bucks good luck
The following users liked this post:
powerstrokin02 (01-03-2012)
#7
Be careful when u take the cover and holder off because if a resistor did come lose then it will be sitting in the black holder and the r really small and hard to find if they fall. I got luck because i have tan carpet,but if u or ur buddy has dark carpet good luck is all i can say.
#8
Powerstrokin02 check that post, those overhead computers have a problem with the resistors after awhile will come lose and to fix them all u will have to do is resolder them back in to place and wham bam thank you mama it works again but if there is a different problem search on ebay for ford overhead computer there is a company that will fix for around 30 bucks good luck
#9
#10
I have been clickin and sniffin but can't seem to find the link you sent. I must be dislexic! Can you make the link more direct? Copy the URL or something? I am all about trying to fix it myself, just need some help locating the solution. Thanks for your help!