starter mount broken????
#11
#13
the only thing I can think of as to how it broke is that my tranny is about to give out and maybe it locked up while the starter was trying to turn the engine over... I didn't have much of a reverse gear if I just put the tranny in reverse and idled it it would move... but if I pushed down on the skinny pedal it would just sit there like it was slipping...
The spacer goes from the starter mount area up and only halfway down the driver side... its not a full ring just like 3/4 round.
The spacer goes from the starter mount area up and only halfway down the driver side... its not a full ring just like 3/4 round.
#14
#16
I found a junk yard that has 5-6 of them sitting on a shelf... he said they all look identical to each other... he marked what they came out of and he has from the 94 year up to late 99 (which is the one he is selling me for $50).... I will post up pictures when I get that sucker off... its been below 32 degrees here so havent had the desire to climb under the truck... specially seeing I have two other vehicles to drive...
#18
I took a piece of 3/4" sheathing and two short pieces of a 4x4 to make a C shape cradle for my trans. I placed that on top of my motorcycle jack and used two straps to hold the trans and cradle to the motorcycle jack platform. Left the transfer case on and dropped it myself. Getting it back in by myself wasn't bad either with this setup.
Last edited by Clark Kent; 12-12-2011 at 10:53 PM.
#19